N° 777
|
Defect recognition on saw blade discs
Defects on saw blade discs should be detected.
|
|
N° 107
|
电子产品针脚宽度检测 如图所示,SI平行光幕用于检测该电子产品的针脚宽度。
Pin width control of electrical components
The width of the pins of an electrical component should be controlled.
|
|
N° 105
|
喷涂量控制 对喷嘴的喷涂量/喷涂浓度进行控制。
Spray jet amount control
The density of the spray jet should be controlled.
|
|
N° 102
|
灯丝螺旋位置检测 在灯泡行业,灯丝的螺旋形线圈的位置必须被控制。通常有两种不同的螺旋样式分别有着不同的间隙。灯丝的行进速度约为0.02m/s,根据不同的灯丝型号,灯丝的外径不同(最小0.3mm,最大1.5mm),灯丝螺旋线圈之间的最大间隙是1mm。
Spiral position control on a filament
The position of the spiral coil on a filament for the light bulb industry must be controlled. There are two different types of spirals, different in gapping, on the filament. The speed of the filament is approximately 0.02m/s, the diameter of the filament is dependent of the type (min. 0.3mm and max. 1.5mm) and the maximum gapping of the spiral is 1mm.
|
|