N° 777
|
Döner testere disklerindeki hataların algılanması Hasarlı döner testere diskleri algılanacaktır.
Defect recognition on saw blade discs
Defects on saw blade discs should be detected.
|
|
N° 107
|
Elektrik bileşenlerin pim genişlik kontrolü Elektrik bileşenlerin pim genişlik kontrolü gerçekleştirilebilir.
Pin width control of electrical components
The width of the pins of an electrical component should be controlled.
|
|
N° 105
|
Sprey jet miktar kontrolü Sprey jet yoğunluk kontrolü gerçekleştirilebilir.
Spray jet amount control
The density of the spray jet should be controlled.
|
|
N° 102
|
Bir filaman üzerinde spiral pozisyonun kontrolü Işık ampül endüstrisinde kullanılan bir filaman üzerindeki spiral sarımın pozisyonu kontrol edilebilir. Filaman üzerinde boşlukları farklı olan iki tür spiral mevcuttur. Filaman hızı yaklaşık olarak 0.02 m/s, çapı türüne göre 0.3mm-1.5mm arasında değişmektedir ve spiraller arası maksimum boşluk 1mm’ dir.
Spiral position control on a filament
The position of the spiral coil on a filament for the light bulb industry must be controlled. There are two different types of spirals, different in gapping, on the filament. The speed of the filament is approximately 0.02m/s, the diameter of the filament is dependent of the type (min. 0.3mm and max. 1.5mm) and the maximum gapping of the spiral is 1mm.
|
|