N° 341
|
Plastic film plunging control
Folds in a matt plastic film should be detected.
|
|
N° 281
|
Ejection control of stamping parts
Due to stamping tool protection reasons the ejection of very small stamping parts should be controlled and the parts counted. The ejection speed of the parts is in the range of a few m/s.
|
|
N° 240
|
Concentric runout control of a wheel
The concentricity of a high speed wheel should be controlled.
|
|
N° 239
|
Detection of a color mark on a transparent plastic film
A color mark on a transparent plastic film should be detected. The sensor is used in the Ɛx – range, thus, an optical fiber unit is necessary.
|
|
N° 180
|
Detection of a perforation line in a plastic film
A perforation line should be detected in a plastic film. At this, the speed of the plastic film is a few m/s and the diameter of the holes in the plastic film is approximately 0.3mm.
|
|
N° 110
|
Spray jet control in the Ɛx range
For the spray jet control in the Ɛx range (zone 0) the most suitable system is a unit which comes without electronically components in the Ɛx zone, but with fiber optics.
|
|