Praktische Beispiele aus dem industriellen Einsatz
R-S-A3.0-(3.0)-...
1) Sprache auswählen:
|
Измерение количества сажи на фильтровальной бумаге Необходимо определить количество сажи на фильтровальной бумаге. Soot quantity measurement on filter paper The amount of soot on filter paper should be measured. |
|
||
|
Color control of flames The color of a flame should be controlled. |
|
||
|
Color measurement of plastic components Plastic components should be color measured |
|
||
|
Color differentiation of shiny plastic parts Shiny plastic components, used for the interior automotive field, should be color differentiated. |
|
||
|
Color differentiation of matt plastic interior components Matt plastic parts, used for the automotive interior field, should be color differentiated. |
|
||
|
Color differentiation of beige interior plastic parts Beige plastic parts, which are used in the automotive interior field, should be color differentiated. |
|
||
|
Plastic ring bottom side – upper side differentiation Plastic rings which are transported on a conveyor belt should be differentiated with a view to the direction (bottom side – upper side). |
|
||
|
Spray jet control with reflected light The spray jet should be controlled with reflected infrared light and in an Ɛx zone environment. |
|
||
|
Color differentiation of make-up The color of make-up should be controlled. |
|
||
|
Color differentiation of eye shadows The color of eye shadows should be controlled. |
|
||
|
Color differentiation of lipsticks The color of lipsticks should be controlled. |
|
||
|
Presence control of a Velcro® strip on rear shelf The presence of a Velcro® strip on a hat shelf should be controlled. |
|
||
|
Plastic film position control on cartons The correct position of a plastic film on a carton should be monitored. At this, the plastic film should cover the upper end of the carton around 10mm. |
|
||
|
Color control of plastic pins Plastic pins which are used for seat belts should be color differentiated. |
|
||
|
Detection of red and white diffuse light on interior components The diffuse red and white light should be detected on interior components. |
|
||
|
Detection of a photosensitive stripe on a metal plate A photosensitive stripe should be detected on a metal sheet. At this, lightning sources which are working in the visible range cannot be used. |
|
||
|
Detection of a gap between successive hygiene articles during the transportation in a conveyor belt Panty liners will be transported between two belts. The beginning as well as the end of a panty liner should be detected. Furthermore, a gap between two successive panty liners should be detected. The only practicable possibility is to look through the two conveyor belts. |
|
||
|
Color control of lacquers The lacquer should be inline controlled. At this a special casing is used which will be plunged into the lacquer. |
|
TOP