Aplikacje dla użytkowników!
D-S-Q4-(28x0.2)-...
1) Wybierz język:
|
监测塑料薄膜上的褶皱 应能在磨砂塑料薄膜的运输过程中检测出是否存在褶皱。 Plastic film plunging control Folds in a matt plastic film should be detected. |
|
||
|
检查冲压件的抛出情况 为保证冲压工具的安全性，应检查冲压件的抛出情况。在此，将在冲压后直接在抛出时检查小型冲压件并对它们计数。零件抛行速度可能达每秒几米。 Ejection control of stamping parts Due to stamping tool protection reasons the ejection of very small stamping parts should be controlled and the parts counted. The ejection speed of the parts is in the range of a few m/s. |
|
||
|
轮盘同心度检测 用于检测图示中高速转动的轮盘的同心度。 Concentric runout control of a wheel The concentricity of a high speed wheel should be controlled. |
|
||
|
透明胶片上的色标检测 检测图示中一条透明胶片上的色标。由于检测区域为危险区域，因此在此采用光纤头进行检测。 Detection of a color mark on a transparent plastic film A color mark on a transparent plastic film should be detected. The sensor is used in the Ɛx – range, thus, an optical fiber unit is necessary. |
|
||
|
塑料薄膜上的齿孔线检测 该应用中，传感器用于检测塑料薄膜上的齿孔线。塑料薄膜运动速度约为几米/秒，齿孔直径约为0.3mm。 Detection of a perforation line in a plastic film A perforation line should be detected in a plastic film. At this, the speed of the plastic film is a few m/s and the diameter of the holes in the plastic film is approximately 0.3mm. |
|
||
|
X-范围内喷雾检测控制 由于该应用不允许在喷雾附近有电子类器件，在此使用光纤式的探测头。 Spray jet control in the Ɛx range For the spray jet control in the Ɛx range (zone 0) the most suitable system is a unit which comes without electronically components in the Ɛx zone, but with fiber optics. |
|
)
